Lo Carbon Sentinel Kinetic FH

• Acoustic Enclosure option for reduced breakout noise
• Acoustic Top Box option for reduced in-duct noise
• Lightweight for easier installation
• Horizontal duct option for space-saving installations
• Integrated digital controller for simple and accurate commissioning
• Plug and play controls; Humidistat, Wireless Remote
• BMS connectivity
• LS inputs (Light Switch)
• Volt-free inputs
• Self diagnosis for simplified fault finding
• Adjustable delay On/delay Off timer

Select a product

Easy Installation
The Sentinel Kinetic models can be mounted vertically in a roof space or in an appropriate cupboard within the dwelling. When mounted in an unheated area the ducting and unit must be insulated in accordance with the Domestic Ventilation Compliance Guide. Ducting can be attached to the unit horizontally, vertically or both.

For scenarios where noise is a critical issue, an Acoustic Enclosure is available to reduce breakout noise and the Acoustic Top Box will reduce in-duct noise at key frequencies. Left (L) or right (R) hand installation. Left hand and right hand units are
available.

Spigot Options
The combination of spigot options allows installation in confined locations. If vertical and horizontal connection is required on the same outlet/inlet, additional spigots can be supplied.

The condensate drain can be taken out through the back, side or bottom of the unit. Using the fittings supplied, the final condensate connection is made outside the unit and can be completed after installation.

Integral Humidity Sensor
The integral humidity sensor increases speed in proportion to relative humidity levels, saving energy and reducing noise. The sensor also reacts to small but rapid increases in humidity, even if the normal trigger threshold is not reached. This unique feature ensures adequate ventilation, even for the smallest wet room. The night time relative humidity setback feature suppresses nuisance tripping as humidity gradually increases with falling temperature.

 
Image of Sentinel Kinetic F
Sentinel Kinetic F
A lightweight, easy to install heat recovery unit suitable for apartments and houses.
Please call 0344 856 0590 for further availability information.
Image of Kinetic FH with Acoustic Enclosure & Top Box
Kinetic FH with Acoustic Enclosure & Top Box

The Acoustic Enclosure reduces breakout noise from the MVHR unit, ensuring occupants are not disturbed by system noise throughout the dwelling. It features internal anti-vibration mounts which prevent vibration passing from the unit through the fabric of the building. 

Please call 0344 856 0590 for further availability information.
Image of Kinetic FH with Top Box
Kinetic FH with Top Box
Please call 0344 856 0590 for further availability information.
Image of Kinetic FH with Acoustic Enclosure
Kinetic FH with Acoustic Enclosure

The Acoustic Enclosure reduces breakout noise from the MVHR unit, ensuring occupants are not disturbed by system noise throughout the dwelling. It features internal anti-vibration mounts which prevent vibration passing from the unit through the fabric of the building. 

Please call 0344 856 0590 for further availability information.
Image of Sentinel Kinetic F (Left Handed)
Sentinel Kinetic F (Left Handed)
A lightweight, easy to install heat recovery unit suitable for apartments and houses.
Please call 0344 856 0590 for further availability information.
Image of Kinetic FH L with Acoustic Enclosure & Top Box
Kinetic FH L with Acoustic Enclosure & Top Box

The Acoustic Enclosure reduces breakout noise from the MVHR unit, ensuring occupants are not disturbed by system noise throughout the dwelling. It features internal anti-vibration mounts which prevent vibration passing from the unit through the fabric of the building. The Acoustic Top Box reduces in-duct noise in living areas, bedrooms and wet rooms. It also provides a neat enclosure for ductwork at the point of installation.

Please call 0344 856 0590 for further availability information.
Image of Kinetic FH L with Top Box
Kinetic FH L with Top Box

The Acoustic Top Box reduces in-duct noise in living areas, bedrooms and wet rooms. It also provides a neat enclosure for ductwork at the point of installation.

Please call 0344 856 0590 for further availability information.
Image of Kinetic FH L with Acoustic Enclosure
Kinetic FH L with Acoustic Enclosure

The Acoustic Enclosure reduces breakout noise from the MVHR unit, ensuring occupants are not disturbed by system noise throughout the dwelling. It features internal anti-vibration mounts which prevent vibration passing from the unit through the fabric of the building. 

Please call 0344 856 0590 for further availability information.
Image of Sentinel Kinetic Wired Remote Controller
Sentinel Kinetic Wired Remote Controller
The Kinetic Wired Remote Controller duplicates all the functions of the on-board controller allowing the unit to be commissioned, controlled and monitored remotely. The controller is supplied with 15 metres of four core cable fitted with an RJ11 plug for fitting to the Kinetic control pcb.
Please call 0344 856 0590 for further availability information.
Image of Wireless enable kit
Wireless enable kit
The Wireless enable kit allows the Kinetic to be set to boost or purge from a remote wireless switch. One switch is supplied with the kit. Up to three additional switches may be linked to the wireless receiver.
Please call 0344 856 0590 for further availability information.
Image of Wireless Transmitter Controller
Wireless Transmitter Controller
• Additional controller for 441865 and 439352 • A maximum of 4 controllers can be used per system • Can be connected to other accessories (eg Humidistat) to send a boost signal wirelessly
Please call 0344 856 0590 for further availability information.
Image of LED Indicator
LED Indicator
Compatible with the Sentinel Kinetic range, the LED Indicator illuminates when the MVHR unit requires a filter check or if the unit has a fault. Supplied with 15 metres of cable. 85 x 85 x 10mm (H x W x D)
Please call 0344 856 0590 for further availability information.
Image of Vent-Axia Visionex PIR
Vent-Axia Visionex PIR

A wall or ceiling mounted movement detector for use with any domestic Vent-Axia mains voltage product. Also suitable for use with Vent-Axia T-Series controllers on ‘Auto’ setting and ITC controllers on sensor mode. Features & Benefits: Adjustable timer overrun (5-25 minutes). Ambient operating temperature range 0°C to +50°C. Designed to meet IP43. Double insulated. Fits any UK single gang mounting box. Internal use only. Maximum load: 600W inductive. Not suitable for use with lighting. No switched live required for internal rooms and toilets. Range of detection up to 10 metres. Supply voltage 220-240V/1/50Hz. Volt-free contacts. Downloads Catalogue Pages

Please call 0344 856 0590 for further availability information.
Acoustic Purge Fan
Please call 0344 856 0590 for further availability information.
Acoustic Purge Fan XL
Please call 0344 856 0590 for further availability information.
Image of Sentinel Kinetic FH Standard Filter
Sentinel Kinetic FH Standard Filter

Sentinel Kinetic FH Standard Filter -  ISO 45% Course  (G3) Filter 2 Pack. Formally known as G3, this filter will provide the minimum required filtration.

Please call 0344 856 0590 for further availability information.
Image of Sentinel Kinetic FH Pollen Filter
Sentinel Kinetic FH Pollen Filter

ISO ePM10 50% (M5) Filter 1 Pack. Formally known as M5, this filter will remove smaller particles, including pollen. 

Please call 0344 856 0590 for further availability information.
Anti Vibration Mounts
Please call 0344 856 0590 for further availability information.

 

Raadpleeg de tab Downloads voor technische informatie

 

 

ESTIMATED RUNNING COSTS

Calculate estimated running costs for this product using the tool below.
For average costs, leave the default values in place or enter your own figures in the boxes to recalculate.
Where a product has multi speeds, a typical installation has been used for the below calculations.


pence
(Your current electricity cost in pence per hour. This will be listed on your electric bill)
hours
(The average number of hours per day fan to run in Trickle mode)
hours
(The average number of hours per day fan to run in Boost mode)

Based on the inputted figures, estimated running costs would be:

Overview

Easy Installation
The Sentinel Kinetic models can be mounted vertically in a roof space or in an appropriate cupboard within the dwelling. When mounted in an unheated area the ducting and unit must be insulated in accordance with the Domestic Ventilation Compliance Guide. Ducting can be attached to the unit horizontally, vertically or both.

For scenarios where noise is a critical issue, an Acoustic Enclosure is available to reduce breakout noise and the Acoustic Top Box will reduce in-duct noise at key frequencies. Left (L) or right (R) hand installation. Left hand and right hand units are
available.

Spigot Options
The combination of spigot options allows installation in confined locations. If vertical and horizontal connection is required on the same outlet/inlet, additional spigots can be supplied.

The condensate drain can be taken out through the back, side or bottom of the unit. Using the fittings supplied, the final condensate connection is made outside the unit and can be completed after installation.

Integral Humidity Sensor
The integral humidity sensor increases speed in proportion to relative humidity levels, saving energy and reducing noise. The sensor also reacts to small but rapid increases in humidity, even if the normal trigger threshold is not reached. This unique feature ensures adequate ventilation, even for the smallest wet room. The night time relative humidity setback feature suppresses nuisance tripping as humidity gradually increases with falling temperature.

Technical

 

Models

Image of Sentinel Kinetic F
Sentinel Kinetic F
A lightweight, easy to install heat recovery unit suitable for apartments and houses.
Please call 0344 856 0590 for further availability information.
Image of Kinetic FH with Acoustic Enclosure & Top Box
Kinetic FH with Acoustic Enclosure & Top Box

The Acoustic Enclosure reduces breakout noise from the MVHR unit, ensuring occupants are not disturbed by system noise throughout the dwelling. It features internal anti-vibration mounts which prevent vibration passing from the unit through the fabric of the building. 

Please call 0344 856 0590 for further availability information.
Image of Kinetic FH with Top Box
Kinetic FH with Top Box
Please call 0344 856 0590 for further availability information.
Image of Kinetic FH with Acoustic Enclosure
Kinetic FH with Acoustic Enclosure

The Acoustic Enclosure reduces breakout noise from the MVHR unit, ensuring occupants are not disturbed by system noise throughout the dwelling. It features internal anti-vibration mounts which prevent vibration passing from the unit through the fabric of the building. 

Please call 0344 856 0590 for further availability information.
Image of Sentinel Kinetic F (Left Handed)
Sentinel Kinetic F (Left Handed)
A lightweight, easy to install heat recovery unit suitable for apartments and houses.
Please call 0344 856 0590 for further availability information.
Image of Kinetic FH L with Acoustic Enclosure & Top Box
Kinetic FH L with Acoustic Enclosure & Top Box

The Acoustic Enclosure reduces breakout noise from the MVHR unit, ensuring occupants are not disturbed by system noise throughout the dwelling. It features internal anti-vibration mounts which prevent vibration passing from the unit through the fabric of the building. The Acoustic Top Box reduces in-duct noise in living areas, bedrooms and wet rooms. It also provides a neat enclosure for ductwork at the point of installation.

Please call 0344 856 0590 for further availability information.
Image of Kinetic FH L with Top Box
Kinetic FH L with Top Box

The Acoustic Top Box reduces in-duct noise in living areas, bedrooms and wet rooms. It also provides a neat enclosure for ductwork at the point of installation.

Please call 0344 856 0590 for further availability information.
Image of Kinetic FH L with Acoustic Enclosure
Kinetic FH L with Acoustic Enclosure

The Acoustic Enclosure reduces breakout noise from the MVHR unit, ensuring occupants are not disturbed by system noise throughout the dwelling. It features internal anti-vibration mounts which prevent vibration passing from the unit through the fabric of the building. 

Please call 0344 856 0590 for further availability information.

Accessories

Image of Sentinel Kinetic Wired Remote Controller
Sentinel Kinetic Wired Remote Controller
The Kinetic Wired Remote Controller duplicates all the functions of the on-board controller allowing the unit to be commissioned, controlled and monitored remotely. The controller is supplied with 15 metres of four core cable fitted with an RJ11 plug for fitting to the Kinetic control pcb.
Please call 0344 856 0590 for further availability information.
Image of Wireless enable kit
Wireless enable kit
The Wireless enable kit allows the Kinetic to be set to boost or purge from a remote wireless switch. One switch is supplied with the kit. Up to three additional switches may be linked to the wireless receiver.
Please call 0344 856 0590 for further availability information.
Image of Wireless Transmitter Controller
Wireless Transmitter Controller
• Additional controller for 441865 and 439352 • A maximum of 4 controllers can be used per system • Can be connected to other accessories (eg Humidistat) to send a boost signal wirelessly
Please call 0344 856 0590 for further availability information.
Image of LED Indicator
LED Indicator
Compatible with the Sentinel Kinetic range, the LED Indicator illuminates when the MVHR unit requires a filter check or if the unit has a fault. Supplied with 15 metres of cable. 85 x 85 x 10mm (H x W x D)
Please call 0344 856 0590 for further availability information.
Image of Vent-Axia Visionex PIR
Vent-Axia Visionex PIR

A wall or ceiling mounted movement detector for use with any domestic Vent-Axia mains voltage product. Also suitable for use with Vent-Axia T-Series controllers on ‘Auto’ setting and ITC controllers on sensor mode. Features & Benefits: Adjustable timer overrun (5-25 minutes). Ambient operating temperature range 0°C to +50°C. Designed to meet IP43. Double insulated. Fits any UK single gang mounting box. Internal use only. Maximum load: 600W inductive. Not suitable for use with lighting. No switched live required for internal rooms and toilets. Range of detection up to 10 metres. Supply voltage 220-240V/1/50Hz. Volt-free contacts. Downloads Catalogue Pages

Please call 0344 856 0590 for further availability information.
Acoustic Purge Fan
Please call 0344 856 0590 for further availability information.
Acoustic Purge Fan XL
Please call 0344 856 0590 for further availability information.
Image of Sentinel Kinetic FH Standard Filter
Sentinel Kinetic FH Standard Filter

Sentinel Kinetic FH Standard Filter -  ISO 45% Course  (G3) Filter 2 Pack. Formally known as G3, this filter will provide the minimum required filtration.

Please call 0344 856 0590 for further availability information.
Image of Sentinel Kinetic FH Pollen Filter
Sentinel Kinetic FH Pollen Filter

ISO ePM10 50% (M5) Filter 1 Pack. Formally known as M5, this filter will remove smaller particles, including pollen. 

Please call 0344 856 0590 for further availability information.
Anti Vibration Mounts
Please call 0344 856 0590 for further availability information.

Downloads